enable mpls

Description

This command has no arguments or variables.

Disabled.

Enabling MPLS allows MPLS processing to begin for any enabled MPLS protocols (RSVP-TE and/or LDP).

While MPLS is transitioning to the enabled state, only the MPLS show commands are accepted.

Before you can enable MPLS on a SummitStack, the stack must meet the following requirements:

Each stack switch must meet the software and hardware requirements listed in the ExtremeXOS 22.2 Feature License Requirements document.
You must configure the enhanced stacking protocol on each Summit family switch.
Note
When MPLS is enabled on a stack, you can only add a MPLS-compatible Summit family switches to the stack.

The following command globally enables MPLS on the switch:

enable mpls

This command was first available in ExtremeXOS 11.6.

This command is available only on the platforms that support MPLS as described in the ExtremeXOS 22.2 Feature License Requirements document.

Published August 2017prev | next