enable edp ports

enable edp ports [ports | all]

Description

Enables the EDP (Extreme Discovery Protocol) on one or more ports.

Syntax Description

`ports`	Specifies one or more ports or slots and ports.
all	Specifies all ports on the switch.

Default

Enabled.

Usage Guidelines

On a SummitStack, ports can be a list of slots and ports. On a stand-alone switch, ports can be one or more port numbers. For a detailed explanation of port specification, see Port Numbering in Command Reference Overview

EDP is useful when Extreme Networks switches are attached to a port.

The EDP is used to locate neighbor Extreme Networks switches and exchange information about switch configuration. When running on a normal switch port, EDP is used to by the switches to exchange topology information with each other. Information communicated using EDP includes the following:

Switch MAC address (switch ID).
Switch software version information.
Switch IP address.
Switch VLAN (Virtual LAN) information.
Switch port number.
Switch port configuration data: duplex, and speed.

Example

The following command enables EDP on port 3 on a switch:

enable edp ports 3

History

This command was first available in ExtremeXOS 10.1.

The port configuration data was added in ExtremeXOS 11.0.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published August 2017prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback