configure syslog reference-identifier

configure syslog [all |ipaddress {tls-port tls_port}] {vr vr_name} {local} reference-identifier reference_identifier

Description

Specifies the remote Syslog server certificate reference identifier.

all	All specified targets.
`ipaddress`	Specifies the remote Syslog server IPv4 or IPv6 address.
tls-port	Specifies using a remote Syslog server Transport Layer Security (TLS) port.
`tls_port`	Specifies the remote Syslog server Transport Layer Security (TLS) port (default is 6514).
vr	Specifies a virtual router.
`vr_name`	Specifies the virtual router ID.
`local`	Specifies the remote Syslog server facility: "local0" "local1" "local2" "local3" "local4" "local5" "local6" "local7".
reference-identifier	Remote Syslog server certificate reference identifier.
`reference_identifier`	Identifier value (for example, the host name). If none is specified, the existing reference identifier configuration is removed.

If a TLS port is not specified, the default is 6514.

The following example specifies the reference identifier as "hostname" for all specified targets on VR "vr1":

# configure syslog all vr vr1 reference-identifier hostname

This command was first available in ExtremeXOS 22.3.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published August 2017prev | next