configure network-clock ptp boundary delete unicast-slave

configure network-clock ptp boundary delete unicast-slave ipv4_address {vlan} vlan_name

Description

Deletes an entry from the unicast slave table for a PTP clock instance. This command is available only for boundary clocks.

boundary	Boundary clock instance.
unicast-slave	IP addresses that are potential slave to the local clock.
`ipv4_address`	IPv4 address.
vlan	VLAN (Virtual LAN).
`vlan_name`	Name of the specific VLAN to add for the PTP clock instance.

The default configuration of clock port is slave mode.

Use this command to delete an entry from the unicast slave table for a PTP clock instance.

The following command removes a static unicast master entry from boundary clock:

configure network-clock ptp boundary delete unicast-slave 192.168.1.1 vlan lpbk-gm

This command was first available in ExtremeXOS 15.1.

This command is available on Summit X770, X670-G2, and X460-G2 series switches.

Note

PTP commands can be used only with the Network Timing feature pack.

Published August 2017prev | next