show vlan l2pt

show [vlan | vman] vlan_name {ports port_list} l2pt {detail}

Description

Displays the L2PT configuration and status of a service.

Syntax Description

vlan Displays VLAN (Virtual LAN) configuration.
vman Displays VMAN configuration.
vlan_name Specifies a VLAN name.
ports port_list Displays the ports and port list separated by a comma ( , ) or dash ( - ).
detail Displays the L2PT configuration and status in detail.

Default

Disabled.

Usage Guidelines

Use this command to display the L2PT configuration and status of a service.

Example

The following is an example of the show vman ports l2pt command:

# show vman cust2 ports 1:2,1:7 l2pt 

Interface        L2PT Profile Name
---------------  --------------------------------
1:2              my_l2pt_prof
1:7              (none)

The following example illustrates the show vman l2pt ports detail command:

show vman cust2 ports 1:2,1:7 l2pt detail
Port 1:2   
        L2PT Profile Name      : my_l2pt_profile    
        Protocol Filter Name   : filter1   
            Destination Address: 01:80:C2:00:00:02   
            Protocol Id Type   : etype  
             Protocol Id Value  : 0x8902    
           Field Offset       : 14   
            Field Value        : 03   
            Field Mask         : FF   
            Action             : Tunnel   
            CoS                : Default  
            Packets Transmitted: 2300        
            Packets Received   : 2300    
        Protocol Filter Name   : filter2   
            Destination Address: 01:80:C2:00:00:00   
            Protocol Id Type   : snap   
            Protocol Id Value  : 0x4041   
            Field Offset       :   
            Field Value        :   
            Field Mask         :   
            Action             : Tunnel   
            CoS                : 7   
            Packets Transmitted: 500   
            Packets Received   : 500 
Port 1:7   
        L2PT Profile Name      : (none)

History

This command was first available in ExtremeXOS 15.5.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.