disable nodealias protocol

disable nodealias protocol [protocol_name | any]

Description

This command designates the specific protocols to remove from the list of detected protocols for the Node Alias feature. Node Alias discovers information about the end systems on a per-port basis. Information from packets from end systems, such as VLANID, source MAC address, source IP address, protocol, etc. are captured in a database that can be queried.

Syntax Description

nodealias Node Alias feature that maps source IP address, MAC address, host name, and protocol on a per port basis.
protocol Designates selection of protocols to detect.
protocol_name Specifies disabling a protocol to detect (one at a time). The following protocols are enabled by default: IPv4, IPv6, OSPF (Open Shortest Path First), BGP (Border Gateway Protocol), VRRP (Virtual Router Redundancy Protocol), DHCPS, DHCPC, BOOTPS, BOOTPC, UDP, BPDU, LLMNR, SSDP, and mDNS.
any Specifies disabling all protocols.

Default

The following protocols are enabled by default: IPv4, IPv6, OSPF, BGP, VRRP, DHCPS, DHCPC, BOOTPS, BOOTPC, UDP, BPDU, LLMNR, SSDP, and mDNS.
Note

Note

  • ARP is categorized under IP.
  • UDP entry is created when destination IP address is broadcast.
  • BPDU means STP (Spanning Tree Protocol) and GVRP frames.

Usage Guidelines

By default, the following protocols are enabled (IPv4, IPv6, OSPF, BGP, VRRP, DHCPS, DHCPC, BOOTPS, BOOTPC, UDP, BPDU, LLMNR, SSDP, mDNS). You can optionally disable any of these protocols (and then enable them back if desired).

Example

The following example disables BGP from being detected:

disable nodealias protocol bgp

History

This command was first available in ExtremeXOS 22.2.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.