configure snmp delete trapreceiver

configure snmp delete trapreceiver [[ip_address | ipv6_address] {port_number} | all]

Description

Deletes a specified trap receiver or all authorized trap receivers.

Syntax Description

ip_address Specifies an SNMP (Simple Network Management Protocol) trap receiver IPv4 address.
ipv6_address Specifies an SNMP trap receiver IPv6 address.
port_number Specifies the port associated with the receiver.
all Specifies all SNMP trap receiver IP addresses.

Default

The default port number is 162.

Usage Guidelines

Use this command to delete a trap receiver of the specified IPv4 or IPv6 address, or all authorized trap receivers.

This command deletes only the first SNMPv1/v2c trap receiver whose IP address and port number match the specified value.

Example

The following command deletes the trap receiver 10.101.0.100 from the trap receiver list:

configure snmp delete trapreceiver 10.101.0.100

The following command deletes entries in the trap receiver list for 10.101.0.100, port 9990:

configure snmp delete trapreceiver 10.101.0.100 9990

Any entries for this IP address with a different community string will not be affected.

History

This command was first available in ExtremeXOS 10.1.

IPv6 support was added in ExtremeXOS 12.4.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.