Configures the server information for a TACACS+ authentication server.
primary | Configures the primary TACACS+ server. |
secondary | Configures the secondary TACACS+ server. |
ipaddress | The IP address of the TACACS+ server being configured. |
hostname | The host name of the TACACS+ server being configured. |
tcp_port | The TCP port to use to contact the TACACS+ server. |
ipaddress | The IP address used by the switch to identify itself when communicating with the TACACS+ server. |
vr_name | Specifies the virtual router
on which the client IP is located. Note: User-created VRs are
supported only on the platforms listed for this feature in the ExtremeXOS 22.2 Feature License Requirements document.
|
TACACS+ uses TCP port 49. The default virtual router is VR-Mgmt, the management virtual router.
Use this command to configure the server information for a TACACS+ server.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]Use of the hostname parameter requires that DNS be enabled.
The following command configures server tacacs1 as the primary TACACS+ server for client switch 10.10.20.35 using a virtual router interface of VR-Default:
configure tacacs primary server tacacs1 client-ip 10.10.20.35 vr vr-Default
This command was first available in ExtremeXOS 10.1.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.