enable snmp traps l3vpn

enable snmp traps l3vpn {vr vr_name}

Description

Use this command to turn on SNMP (Simple Network Management Protocol) trap support for L3 VPN.

Syntax Description

vr_name Specifies the name of the parent VR where this RFC 4382 scalar is applied. If VR name is not provided, then this command is applied to the VR in the current context.

Default

Enabled.

Usage Guidelines

Use this command to enable generation of L3VPN SNMP traps—mplsL3VpnVrfUp and mplsL3VpnVrfDown. These trap notifications are sent under the following conditions:

  • mplsL3VpnVrfUp—first IP VLAN (Virtual LAN) becomes active and administrative state is enabled.
  • mplsL3VpnVrfDown—last active IP VLAN becomes inactive OR administrative state is disabled.

Example

The following example enables L3 VPN SNMP traps support on the switch:

enable snmp traps l3vpn vr vr-default

History

This command was first available in ExtremeXOS 15.3.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.