configure isis hello-multiplier

configure isis [vlan all | {vlan} vlan_name] hello-multiplier multiplier {level [1 | 2]}

Description

This command sets the hello multiplier for one or all IS-IS VLAN (Virtual LAN)s.

Syntax Description

vlan all Applies the configuration to all IS-IS VLANs.
vlan_name Specifies a single VLAN to which the configuration applies.
multiplier Sets the hello multiplier. The range is 2 to 100.
level [1 | 2] Limits the configuration to either level 1 or level 2. If neither level 1 nor level 2 is specified, the configuration applies to both levels.

Default

3.

Usage Guidelines

The hello multiplier is used in conjunction with the hello interval to compute the holding time. The holding time is included in hello PDUs and is calculated by multiplying the hello multiplier by the hello interval. If the hello interval is set to minimal, the holding time is set to 1 second and the hello interval is calculated by dividing 1 second by the hello multiplier. For example, a hello interval of minimal and a hello multiplier of 4 means that the hold interval is set to 250 ms (and the holding time to 1 second). The holding time tells the neighboring router how long to wait before declaring the sending router dead.

Example

The following command sets the SJvlan hello multiplier to 4:

configure isis SJvlan hello-multiplier 4

History

This command was first available in ExtremeXOS 12.1.

Platform Availability

This command is available on platforms with a Core license.