Displays information about one or all OSPF (Open Shortest Path First) interfaces.
| vlan-name | Specifies a VLAN (Virtual LAN) name. | 
| area-identifier | Specifies an OSPF area. | 
| enabled | Displays only OSPF enabled interfaces. | 
If no argument is specified, all OSPF interfaces are displayed.
Not applicable.
The following command displays information about one or all OSPF interfaces on the VLAN accounting:
show ospf interfaces vlan accounting
The following output displays BFD protection configuration information:
# show ospf interfaces       
VLAN      IP Address         AREA ID        Flags      Cost State   Neighbors   
HQ_10_0_2  10.0.2.2       /24 0.0.0.0         -rifb--      4/A DR        1   
HQ_10_0_5  10.0.5.2       /24 0.0.0.0         -rif---      4/A BDR       1       
Flags:  b – BFD protection configured, D - Duplicate address detected on VLAN,           
        f - Interface Forwarding Enabled, i - Interface OSPF Enabled,           
        n - Multinetted VLAN, p - Passive Interface, r - Router OSPF Enable,           
        T - Tentative address.   
Cost:   A - Automatic Cost, C - Configured Cost.       
Total number of interfaces: 2
            The following output displays the BFD session state:
Interface(rif1000027): 10.0.2.2/24 Vlan: HQ_10_0_2 OSPF: ENABLED Router: ENABLED   
AreaId: 0.0.0.0  RtId: 10.0.2.2  Link Type: broadcast(auto)  Passive: No   
Cost: 4/A  Priority: 10 Transit Delay: 1   DAD State:Valid   
Hello Interval: 10s  Rtr Dead Time: 40s Retransmit Interval: 5s   
Wait Timer: 40s   
Authentication: NONE   
State: DR   Number of events: 1   
DR RtId: 10.0.2.2  DR IP addr: 10.0.2.2 BDR IP addr: 10.0.2.1   
Num Neighbor State Change to FULL : 1   
BFD Protection: On       
Neighbors:  
    RtrId: 10.0.3.1 IpAddr: 10.0.2.1  Pri: 5  Type: Auto      
    State: FULL Dr: 10.0.2.2  BDR: 10.0.2.1  Dead Time: 00:00:00:03      
    Options (0x42): Opaque LSA: Yes      
    BFD Session State: Active
        This command was first available in ExtremeXOS 10.1.
The enabled option was added in ExtremeXOS 12.2.
BFD display output was added in 15.3.2.
This command is available on platforms with an Advanced Edge or Core license as described in the ExtremeXOS 22.2 Feature License Requirements document.
 Print
                        this page
Print
                        this page Email this topic
Email this topic Feedback
Feedback View PDF
View PDF Download EPUB
Download EPUB