configure ip-security anomaly-protection notify trigger on

configure ip-security anomaly-protection notify trigger on value {slot [slot | all ]}

Description

Configures an anomaly rate-based notification feature.

Syntax Description

value Specifies the number of events for the trigger.
slot Specifies the slot to be used.
all Specifies all IP addresses, or all IP addresses in a particular state.

Default

The default is 1.

Usage Guidelines

This is a paired command with configure ip-security anomaly-protection notify trigger off that configures an anomaly rate-based notification feature. The anomaly notification is automatically triggered if the rate of anomaly events is greater than the configured ON value, and the notification is disabled if the rate falls below the value set in the configure ip-security anomaly-protection notify trigger off command.

The command takes effects after the anomaly notification is enabled.

Note

Note

The value set in ON must be greater than or equal to the value set in OFF.

History

This command was first available in ExtremeXOS 12.0.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.