configure policy resource-profile

configure policy resource-profile [default |less-acl [more-ipv4 | more-ipv4-no-ipv6] | [more-ipv4-no-ipv6 |more-mac-no-ipv6]]

Description

Configures a profile that controls the policy rule resources available for MAC/IPv4/IPv6/L2.

Syntax Description

default	Configure a profile with the default settings.
less-acl	Configure a profile that removes some access list resources to be used for rules.
more-ipv4	Configure a profile that adds IPv4 rules.
more-ipv4-no-ipv6	Configure a profile that adds IPv4 rules at the expense of IPv6 rules.
more-mac-no-ipv6	Configure a profile that adds MAC rules at the expense of IPv6 rules.

Default

None.

Usage Guidelines

You cannot configure the system to use a new resource profiles while policy is enabled. You must disable policy first.

You cannot configure the system to use a new resource-profile where the profile does not fit with existing defined rules. An error message similar to the following appears:

Current IPv6 rule usage 1 is higher than max value 0 supplied by profile more-mac-no-ipv6

Example

The following example configures the system to use the resource settings of more-ipv4-no-ipv6:

configure policy resource-profile more-ipv4-no-ipv6

History

This command was first available in ExtremeXOS 22.1.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published August 2017prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback