configure pim register-checksum-to

configure pim {ipv4 | ipv6} register-checksum-to [include-data | exclude-data]


Configures the checksum computation to either include data (for compatibility with Cisco Systems products) or to exclude data (for RFC-compliant operation), in the register message.

Syntax Description

ipv4 Specifies the IPv4 address family.
ipv6 Specifies the IPv6 address family.
include-data Specifies to include data.
exclude-data Specifies to exclude data.


Exclude data.

Usage Guidelines



The following example configures the checksum mode to include data for compatibility with Cisco Systems products:

configure pim register-checksum-to include-data


This command was first available in ExtremeXOS 10.1.

Platform Availability

This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the PIM feature, see the ExtremeXOS 22.2 Feature License Requirements document.