configure elrp-client dynamic-vlans client/uplink ports

configure elrp-client dynamic-vlans [netlogin | vm-tracking] [client-ports | uplink-ports] [on | off]

Description

This command turns Extreme Loop Recognition Protocol (ELRP) on/off for client ports or uplink ports for dynamic VLANs.

netlogin	Specifies that the command applies to dynamic VLANs created by Network Login only.
vm-tracking	Specifies that the command applies to dynamic VLANs created by virtual machine MAC tracking only.
client-ports	Specifies client ports only.
uplink-ports	Specifies uplink ports only.
on	Enable ELRP for dynamic VLANs.
off	Disables ELRP for dynamic VLANs.

ELRP for dynamic VLANs is "off" by default.

The following example enables ELRP for Netlogin dynamic VLANs on uplink ports only:

configure elrp-client dynamic-vlans netlogin uplink-ports on

This command was first available in ExtremeXOS 22.2.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published August 2017prev | next