show ipmroute

show ipmroute {source-net mask-len | source-net mask | summary} {vr vr-name}


Displays the contents of the IP multicast routing table or the route origin priority.

Syntax Description

source-net Specifies an IP address/mask length.
mask-len Mask length for the IP multicast source's subnet. Range is 1–32.
mask Specifies a subnet mask.
summary Displays the statistics of multicast static routes.
vr-name Specifies the virtual router to which the route is added.


vr-name is the VR of the current CLI context.

Usage Guidelines

This command allows you to view the configured multicast static routes. You can specify the filtering criteria on this CLI to view only the desired route. The multicast static routes are displayed in ascending order of their prefix (same order as show iproute displays).


The following example displays a multicast static route from a default virtual router:

* (debug) Summit-PC.19 # show ipmroute
Destination        Gateway         Mtr  Flags Protocol         VLAN
Default Route      255  UG    None             pc4-1
*      10   UG    bgp              pc4-1
*      12   U-    None             pc5-3      10   UG    None             pc4-1
*      8    U-    None             pc5-3      4    UG    None             pc4-1
*      0    UG    None             pc4-1      0    U-    None             pc5-3
*      2    U-    ospf-extern1     pc5-3      0    U-    None             pc5-3
Flags: (*) Active, (G) Gateway,  (U) Up
Mask distribution:
1 default routes                2 routes at length  8
4 routes at length 16           1 routes at length 24
2 routes at length 32
Total number of multicast static routes = 10


This command was first available in ExtremeXOS 11.6.

Platform Availability

This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the IPv4 multicast feature, see the ExtremeXOS 22.2 Feature License Requirements document.