configure erps revert
Add or delete ERPS revert operation along with the “wait-to-restore” time interval.
|ring-name||Alphanumeric string that identifies the ERPS ring.|
|enable||Enable revert mode to ERPS ring.|
|disable||Disable revert mode from ERPS ring.|
The default is the revertive mode (enable).
Use this command to enable/disable a G.8032 ring to revert to the original ring protection link (RPL) block state.
The following command disables revert mode from an ERPS ring named “ring1”:
configure erps ring1 revert disable
This command was first available in ExtremeXOS 15.1.