configure bfd hardware-assist loopback-port
Description
This command adds the specified port as a primary or secondary loopback port to enable BFD hardware assist mode.
Syntax Description
primary | Unused front-panel primary port dedicated to Hardware Assist. |
secondary | Unused front-panel secondary port dedicated to Hardware Assist. |
loopback-port | Port to be configured as loopback. |
port | Port number. |
none | Unconfigures the port number and disables hardware assist if only the primary loopback port (or secondary loopback port) is configured. |
Default
None.
Usage Guidelines
The unused front panel port can be configured as a loopback port to enable BFD hardware assist mode. The primary or secondary loopback port must be configured for this feature. The loopback-port is not available for switching the user-data traffic, but is used internally by the BFD hardware to send control packets. This port must not be part of any VLAN and should not be a trunk port. Use the none option to unconfigure the loopback port and disable hardware assist if only the primary loopback port (or secondary loopback port) is configured. Make sure that other applications have not already configured these ports as loopback ports. Use the show bfd command to view the configured loopback ports. Configuring "not-present" ports as loop-back ports is not supported.
Example
The following command configures port 10 as the primary loopback port for the BFD hardware assist feature:
configure bfd hardware-assist primary loopback-port 10
The following command configures port 11 as secondary loopback port for BFD hardware assist feature:
configure bfd hardware-assist secondary loopback-port 11
The following command unconfigures the primary loopback port:
configure bfd hardware-assist primary loopback-port none
configure bfd hardware-assist secondary loopback-port none
History
This command was first available in ExtremeXOS 21.1.
Platform Availability
This command is available on the ExtremeSwitching X460-G2, X465 X590, and X695.