unconfigure stacking-support
Description
This command resets the stacking parameters configured with commands that use the stacking-support keyword.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
Run this command from the local node on which you want to reset stacking-support parameters.
This command resets the stacking parameters configured
with the following commands that use the stacking-support keyword:
-
configure stacking-support
Example
To unconfigure the stacking-support parameters on the local node, use the following command:
unconfigure stacking-support The stacking-support configuration has been reset. The defaults will take effect at the next reboot of this switch.
History
This command was first available in ExtremeXOS 12.5.
Platform Availability
This command is available on all platforms that support alternate stack port selection or permit disabling of the stacking-support option.