configure ports link-flap-detection action
Add or deletes actions (disabling ports, logging events, generating SNMP traps) to be taken when excessive link flapping is detected.
|port_list||List of ports to set link-flap detection actions upon.|
|all||Sets the configured action for link-flap detection upon all ports in the system.|
|action||Sets actions to be taken when excessive link flapping is detected.|
|disable-port||Disables selected ports if link-flap threshold is exceeded. After a port is disabled, the port either stays down for the configured disable time value (set in the configure ports link-flap-detection interval threshold disable-time command) or can be re-enabled manually using the clear ports link-flap-detection status command.|
|log||Generates a log event if link-flap threshold is exceeded.|
|trap||Generates an SNMP trap if link-flap threshold is exceeded.|
|all-actions||Adds or deletes all the actions.|
By default, all actions are turned off.
The following example adds all link-flap actions (disabling ports, logging events, generating SNMP traps) on ports 3–10:
configure ports 3-10 link-flap-detection action add all-actions
This command was first available in ExtremeXOS 22.1.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.