show ports sharing
Description
Displays port load-sharing groups, or LAGs.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
Output from this command displays the following information:
- Config Master—The port that is configured as the master logical port of the link aggregation group (LAG). This number is also the LAG group ID.
- Current Master—In LACP, this is the port that is currently the LAG group ID, or master logical port for the LAG.
- Agg Control—This is the aggregation control for the specified LAG; it can be either static, LACP or health-check. In LACP, it is the aggregation control for the specified LAG.
- Min Active—The minimum number of active links that must be up for the trunk to remain up.
- Ld Share Algorithm—The algorithm used for the link aggregation. The available link aggregation algorithms vary among platforms; see the ExtremeXOS 32.2 User Guide for more information.
- Ld Share Group—The specific ports that belong to each LAG, or the port numbers in the trunk. A port can belong to only one LAG, either static or dynamic.
- Agg Mbr—In LACP, this shows whether the port has been added to the aggregator or not; it will be either Y for yes or - for no.
- Link State—This is the current status of the link.
- Link Up transitions—Number of times the link has cycled through being up, then down, then up.
- LAG distribution mode—Displays the configured distribution mode and distribution port lists for LAGs.
Example
Following is sample output displaying link aggregation on a switch:
show port sharing Load Sharing Monitor Config Current Agg Min Ld Share Ld Share Agg Link Link Up Master Master Control Active Algorithm Group Mbr State Transitions ============================================================================== 14 <2 L2 14 - R 0 L2 15 - A 1 L2 16 - R 0 17 35 Static 1 L2 17 - R 0 L2 35 Y A 1 ============================================================================== Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback Minimum Active: (<) Group is down. # active links less than configured minimum Load Sharing Algorithm: (L2) Layer 2 address based, (L3) Layer 3 address based (L3_L4) Layer 3 address and Layer 4 port based (custom) User-selected address-based configuration Custom Algorithm Configuration: ipv4 L3-and-L4, xor Custom Hash Seed: Switch MAC address (0x969BF582) Number of load sharing trunks: 2
History
This command was first available in ExtremeXOS 10.1.
The LACP feature was added in ExtremeXOS 11.3.
The Health Check LAG was added in ExtremeXOS 12.1.3.
The round-robin algorithm was added in ExtremeXOS 12.5.
Support for the Min Active parameter was added in ExtremeXOS 15.7.1.
Custom hash seed information was added in ExtremeXOS 30.1.
Platform Availability
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.