Configures the priority value of a VRRP router instance.
| vlan_name |
Specifies the name of a VRRP VLAN. |
| vlan_list | VLAN list (1–4,094). |
| vridval |
Specifies the VRID for the VRRP instance. To display the configured VRRP router instances, enter the show vrrp command. |
| vrid_list | List of virtual router IDs (1–255). |
| priorityval |
Specifies the priority value of the router. The default is 100. The priority range is 1-255. |
The default priority is 100.
This command changes the priority of a VRRP router. If the VRRP router is the IP address owner (which means that the VRRP router IP address matches the VRRP VLAN IP address), the priority is 255 and cannot be changed. If the VRRP router is not the IP address owner, the priority can be changed to values in the range of 1 to 254.
To change the priority of the IP address owner or to make a different VRRP router the IP address owner, disable VRRP and reconfigure the affected switches to use VRRP router addresses that support the priorities you want to assign.
The following command configures a priority of 150 for VLAN vrrp-1:
configure vrrp vlan vrrp-1 vrid 1 priority 150
This command was first available in ExtremeXOS 10.1.
VLAN and VR list options added in ExtremeXOS 22.3.
This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the VRRP feature, see the ExtremeXOS 32.2 Feature License Requirements document.