configure access-list width

configure access-list width [double | single] [slot slotNo | all]


Configures the TCAM width of a switch.

Syntax Description

double Specifies a double wide ACL TCAM. Provides double wide ACL key with additional qualifiers.
single Specifies a single wide ACL TCAM.
slotNo Specifies the slot to configure.
all Specifies all slots.



Usage Guidelines

Use this feature to configure the width of the ACL TCAM key of a slot or switch to be either double wide or single wide.

The switch must be rebooted for the configuration change to take effect.

If you attempt to configure a double wide mode on a slot or switch that does not support it, an error message is displayed.

To display the configured mode, use the show access-list width command.


The following command configures slot 1 to use double wide mode:

# configure access-list width double slot 1


This command was first available in ExtremeXOS 12.5.

Platform Availability

This command is available on the ExtremeSwitching X450-G2, X460-G2, X440-G2, X465, X590, X620, and X695 series switches.