This command displays the endpoint configured values, run-time data, and test session information.
|ipaddress||The endpoint IP address, either IPv4 or IPv6.|
|ip||Specifies the endpoint IP address.|
|port||Specifies the endpoint port.|
|udp-port||The UDP port the endpoint will listen on; range is 1025 – 65535.|
# show twamp endpoint ipaddress 126.96.36.199 port 5000 TWAMP Endpoint Endpoint Information Local Address: 188.8.131.52 Listening Port: 5000 Received Packets: 7948 Transmitted Packets: 7948 Active Sessions: 5 Session created on Thu Nov 13 15:41:49 2014 Peer Address: 184.108.40.206 Port: 11001 Sequence Number: 1575 Last recv'd packet: 84ms Session created on Thu Nov 13 15:41:49 2014 Peer Address: 220.127.116.11 Port: 11002 Sequence Number: 1555 Last recv'd packet: 16ms Session created on Thu Nov 13 15:41:49 2014
This command was first available in ExtremeXOS 16.1.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.