This command configures the circuit type level for one or all IS-IS VLANs.
| vlan all | Applies the selected circuit type to all IS-IS VLANs. |
| vlan_name | Specifies a single VLAN to which the circuit type configuration applies. |
| level [1 | 2 | both-1-and-2] | Sets the circuit type level to level 1, level 2, or to both level 1 and level 2. |
Both-1-and-2.
Hello PDUs are only sent on the specified level for the selected VLANs. This can be useful for level 1/level 2 routers that are neighbors.
Note that for per-level VLAN configurable parameters L1 and L1/L2, point-to-point interfaces use the level 1 parameters, and L2-only point-to-point interfaces use the L2 parameters.
The following command configures all IS-IS VLANs to use circuit type level 1:
configure isis vlan all circuit-type level 1
This command was first available in ExtremeXOS 12.1.
This command is available on platforms with a Core or Premier license as described in the ExtremeXOS 32.2 Feature License Requirements document.