configure policy slices tci-overwrite
Description
Configures the number of slices used by a profile in the look-up stage TCAM resources.
Syntax Description
slices | Configures look-up stage TCAM resources. |
tci-overwrite | Configures look-up Stage TCAM resources used by profile with
tci-overwrite enabled. Note: The ExtremeSwitching X435 platform does not support
TCI-overwrite.
|
slices | Specifies the number of slices between 0 and 4. The default is 4. |
shared | Configures look-up stage TCAM resources. |
shared | Specifies the shared slice value (0–4). |
Default
By default, the number of slices is 4.
Usage Guidelines
This command only runs if policy is disabled.
This command enables you to allocate only the slice resources necessary and allow the rest to be used outside of policy. In a stack with slots having differing VCAP slice depths, each slot has the number of rules available as follows: numSlices * (VCAP slice depth)).
Example
The following example configures policy to use 3 slices with tci-overwrite enabled:
# configure policy slices tci-overwrite 3
History
This command was first available in ExtremeXOS 30.4.
Platform Availability
This command is available on ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620-x series switches.