Enables gPTP on one or more ports.
|port_list||Specifies one or more of the switch‘s physical ports.|
Apply change only to specified port, even if port is master of a load sharing group.
|all||Specifies all of the switch‘s physical ports.|
Use this command to configure on which ports gPTP runs. gPTP does not run on any ports if it is not first enabled in the switch by the enable network-clock gptp command.
# enable network-clock gptp ports 4
This command was first available in ExtremeXOS 15.3.
This command is available on ExtremeSwitching X450-G2 and X460-G2 switches if the AVB feature pack license is installed on the switch..