This command reconfigures the TCP port, the VR, the Source IP Address, and SSL mode of an existing collector.
|hostname||Host name of the collector.|
|ip_address||IPv4 address of the collector.|
|tcp-port||TCP port number that the collector is listening.|
|port||Port number. The range is 1-65535.|
|vr vr_name||Specifies the Virtual router and virtual router name. The default name is VR-Mgmt.|
|from source_ip_address||Specifies the source and the source IPv4 address. The default source is the IP address on VLAN Mgmt.|
|ssl||Specifies the Secure Sockets Layer.|
|on||Specifies that SSL is on.|
|off||Specifies that SSL is off.|
This command reconfigures the TCP port, the VR, the Source IP Address, and SSL mode of an existing collector. The collector to be reconfigured is specified by its hostname or IP address. If the specified collector does not exist, an error message ERROR: The collector 188.8.131.52 does not exists is displayed.
The following command reconfigures the tech support collector:
configure tech-support collector
This command was first available in ExtremeXOS 15.4.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.