configure ospf add virtual-link
Adds a virtual link connected to another ABR.
|router-identifier||Specifies the router ID of the other end of the link.|
|area-identifier||Specifies an OSPF area.|
A virtual link provides a logical path between the ABR of the disconnected area and the ABR of the normal area that connects to the backbone. A virtual link must be established between two ABRs that have a common area, with one ABR connected to the backbone. Specify the following:
- router-identifier—Far-end router interface number.
- area-identifier—Transit area used for connecting the two end-points. The transit area cannot have the area identifier 0.0.0.0. and cannot be a stub area or an NSSA.
The following command configures a virtual link between the two interfaces:
configure ospf add virtual-link 10.1.2.1 10.1.0.0
This command was first available in ExtremeXOS 10.1.
This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS 32.2 Feature License Requirements document.