configure snmpv3 add filter-profile
Associates a filter profile with a parameter name.
|hex_profile_name||Specifies the filter profile name. The value is to be supplied as a colon separated string of hex octets.|
|profile_name||Specifies the filter profile name in ASCII format.|
|hex_param_name||Specifies a parameter name to associate with the filter profile. The value to follow is to be supplies as a colon separated string of hex octets.|
|param_name||Specifies a parameter name to associate with the filter profile in ASCII format.|
|volatile||Specifies volatile storage.|
The default storage type is non-volatile.
Use this command to add an entry to the snmpNotifyFilterProfileTable. This table associates a filter profile with a parameter name. The parameter name is associated with target addresses, and the filter profile is associated with a series of filters, so, in effect, you are associating a series of filters with a target address.
The following command associates the filter profile prof1 with the parameter name P1:
configure snmpv3 add filter-profile prof1 param P1
This command was first available in ExtremeXOS 10.1.
The hex_profile_name and hex_param_name parameters were added in ExtremeXOS 11.0.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.