configure protocol add
Configures a user-defined protocol filter.
|filter||Configures a protocol filter.|
|filter_name||Specifies a protocol filter name.|
|add||Specifies that you add a protocol.|
|delete||Specifies that you delete a protocol.|
|etype||Specifies an ethertype protocol.|
|llc||Specifies LLC protocol.|
|snap||Specifies SNAP protocol.|
|hex|| Specifies a four-digit
hexadecimal number between 0 and FFFF that represents:
Supported protocol types include:
- etype—IEEE Ethertype.
- llc—LLC Service Advertising Protocol.
- snap—Ethertype inside an IEEE SNAP packet encapsulation.
A maximum of 16 customized protocol filters can be active at a time.
The protocol filter must already exist before you can use this command. Use the create protocol command to create the protocol filter.
NoteProtocol-based VLAN for Etype from 0x0000 to 0x05ff are not classifying as per filter. When traffic arrive with these Etypes, it is classifed to native VLAN rather protocol-based VLAN.
The following example adds MPLS to "my_filter":
configure protocol “my_filter” add etype 0x8847 configure protocol filter “my_filter” add etype 0x8847
The following example deletes MPLS from "my_other_filter":
configure protocol “my_other_filter” delete etype 0x8847 configure protocol filter “my_other_filter” delete etype 0x8847
This command was first available in ExtremeXOS 10.1.
The filter keyword and options were added in ExtremeXOS 15.5.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.