Changes the BGP source interface for TCP connections.
| remoteaddr | Specifies the IPv4 or IPv6 address of a BGP neighbor. |
| all | Specifies all IPv4 and IPv6 neighbors. |
| any | Specifies any source interface. |
| ipAddr | Specifies the IP address of a source interface. |
Any.
The source interface IP address must be a valid IP address of any VLAN configured on the switch.
This command applies to the current VR or VRF context.
The following command changes the BGP source interface to 10.43.55.10:
configure bgp neighbor 192.168.1.5 source-interface ipaddress 10.43.55.10
This command was first available in ExtremeXOS 10.1.
This command required a specific license in ExtremeXOS 11.1.
This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the BGP feature, see the ExtremeXOS 32.2 Feature License Requirements document.