configure tech-support collector data-set

configure tech-support collector [ all hostname | ip_address] data-set [ summary | detail ]

Description

This command configures the amount and type of data that is included in the status report for a collector.

Syntax Description

all Configures report data set for all existing collectors.
hostname Specifies the host name of the collector.
ip_address Specifies the IPv4 address of the collector.
data-set Specifies the report data set. The default is detail.
detail Specifies the output of show tech-support area for area general, config, log, VLAN, and EPM.
summary Specifies the output of show tech-support all command.

Default

The default is detail.

Usage Guidelines

This command configures the amount and type of data that is included in the status report for a collector. When you specify all, it configures a report data set for all existing collectors; otherwise report data is set for a particular collector specified by the hostname or IP address. When the data set is set to summary, the status report sent by the switch includes installed ExtremeXOS and Bootrom image versions, the active partition, serial number, equipment type, installed hardware options, stored SRAM contents, basic switch configuration, and log messages. The output of the summary option is collected from the show tech-support area command for the area general, configuration, log, VLAN, and EPM. Changing the report data set to detail will send the full output of the show tech command. When a collector is added, the data set is set to detail.

Example

The following command example configures a specific collector to display a detailed output set:

configure tech-support collector 65.222.234.14 data-set detail

History

This command was first available in ExtremeXOS 15.4.

Platform Availability

This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.