configure ospfv3 area interarea-filter
Description
Configures an inter-area filter policy.
Syntax Description
area_identifier | Specifies the OSPFv3 target area. |
policy_map | Specifies a policy. |
none | Specifies not to apply an inter-area filter (removes the existing policy, if any). |
Default
N/A.
Usage Guidelines
ExtremeXOS OSPFv3 can apply an inter-area policy to filter some inter-area-prefix-LSAs and inter-area-router-LSAs from other areas. This can reduce the size of link state database of routers belonging to the area.
Using the none mode specifies that no external filter is applied.
-
Match attributes:
-
nlri IPv6-address/mask-len
-
-
Action (set) attributes:
-
permit
-
deny
-
Any other policy attribute will not be recognized and will be ignored.
The following is an example of an inter-area filter policy file:
entry one { if match any{ nlri 2001:db8:3e5c::/48; nlri 2001:db8:2146:2341::/64; } then { deny; } } entry two { if match any{ nlri 2001:db8:444::/48; nlri 2001:db8:541f:65bd::/64; } then { permit; } }
Example
The following command configures an inter-area filter policy, nosales for area 1.2.3.4:
configure ospfv3 area 1.2.3.4 interarea-filter nosales
History
This command was first available in ExtremeXOS 11.2.
Platform Availability
This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS 32.2 Feature License Requirements document.