show ospfv3 neighbor

show ospfv3 neighbor {routerid ip_address} {vlan vlan_name | tunnel tunnel_name} {detail}

Description

Displays information about an OSPFv3 neighbor.

Syntax Description

ip_address Specifies a neighbor router ID.
vlan_name Specifies an IPv6 configured VLAN.
tunnel_name Specifies an IPv6 tunnel.
detail Specifies detail information.

Default

If no argument is specified, all OSPFv3 neighbors are displayed.

Usage Guidelines

None.

Example

The following command displays information about the OSPFv3 neighbors on the VLAN accounting:

show ospfv3 neighbor vlan accounting

The following three examples provide sample ouputs for show ospfv3 neighbor:

# show ospfv3 neighbor        

Neighbor ID     Pri State            Up/Dead Time         Interface      InstanceID             
          BFD Session State   
=========================================================================================   
1.1.1.1         1   FULL    /BDR     00:03:40:45/00:00:38 HQ_10_0_4       0             
            Active       

# show ospfv3 neighbor detail        

Neighbor 1.1.1.1, Interface address fe80::201:30ff:fe10:3ae6       
    In the area 0.0.0.0 via interface HQ_10_0_4       
    Neighbor priority is 1,  State is FULL, 1338 events, 6 state changes
    DR is 2.2.2.2 BDR is 1.1.1.1       
    Options is 0x13 (-|R|-|-|E|V6)       
    Neighbor is up for 00:03:42:17       
    Neighbor will be dead in 00:00:37       
    Retransmission queue length is 0       
    BFD Session State: Active        

# show ospfv3 neighbor {vlan} <vlan-name>       

Neighbor ID     Pri State            Up/Dead Time         Interface       InstanceID             
          BFD Session State   
=========================================================================================   
1.1.1.1         1   FULL    /BDR     00:20:37:17/00:00:39 HQ_10_0_4       0             
        Active   
3.3.3.3         1   FULL    /DR      00:20:37:17/00:00:39 HQ_10_0_4       0             
        Active   
4.4.4.4         1   2WAY    /DOTHER  00:20:37:17/00:00:39 HQ_10_0_4       0             
        None

History

This command was first available in ExtremeXOS 11.2.

Platform Availability

This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS 32.2 Feature License Requirements document.