configure auto-peering oneconfig bootprelay

configure auto-peering one-config bootprelay [add | delete] [ip_address | ipv6_address] vr vrname


For Auto-peering, adds dynamic BOOTP relay servers that the DHCP relay agent uses to forward DHCP traffic received from host attachments.

Syntax Description

auto-peering Specifies Auto-peering.
one-config Specifies changing the BGP Auto-peering OneConfig configuration.
bootprelay Specifies configuring dynamic BOOTP relay service applied to dynamically created VRFs.
add Adds dynamic BOOTP relay server.
delete Deletes dynamic BOOTP relay server.
ip_address Specifies the IPv4 address of the BOOTP relay server.
ipv6_address Specifies the IPv6 address of the BOOTP relay server.
vr Specifies selecting the virtual router (VR) If you do not specify a VR or VRF, the current VR context is used.
vrname Specifies the VR name.


If you do not specify a VR or VRF, the current VR context is used.

Usage Guidelines

Dynamic BOOTP relay services are configured after the dynamic VRF is installed on the device.


The following example adds dynamic BOOTP relay server at "" for VR "red":

# configure auto-peering oneconfig bootprelay add vr red


This command was first available in ExtremeXOS 31.1.

Platform Availability

This command is available on the ExtremeSwitching X465, X590, X695 series switches.

This feature requires the Advanced Edge or Base license. For more information about licenses, see the ExtremeXOS 32.2 Feature License Requirements .