show lacp counters
Description
Displays all LACP, or dynamic link aggregation, counters for all member ports in the system.
Syntax Description
This command has no parameters or variables.
Default
N/A.
Usage Guidelines
-
LACP PDUs dropped on non-LACP ports.
-
LACP bulk checkpointed messages sent.
-
LACP bulk checkpointed messages received.
-
LACP PDUs checkpointed sent.
-
LACP PDUs checkpointed received.
-
LAG group ID.
-
Member port.
-
Packets received.
-
Packets dropped from PDU error.
-
Packets dropped because LACP is not enabled on this port.
-
Packets dropped because sender‘s system MAC address matches that of receiver.
-
Packets successfully transmitted.
-
Packets with errors during transmission.
Example
The following command displays LACP counters:
show lacp counters
The following is sample output from this command on a switch:
LACP PDUs dropped on non-LACP ports : 519392 LACP Bulk checkpointed msgs sent : 1 LACP Bulk checkpointed msgs recv : 0 LACP PDUs checkpointed sent : 575616 LACP PDUs checkpointed recv : 0 Lag Member Rx Rx Drop Rx Drop Rx Drop Tx Tx Group Port Ok PDU Err Not Up Same MAC Sent Ok Xmit Err -------------------------------------------------------------------------------- 1:1 1:1 2169 0 0 0 2170 0 1:2 2169 0 0 0 2170 0 1:3 2169 0 0 0 2170 0 1:4 2169 0 0 0 2170 0 1:5 2169 0 0 0 2170 0 1:6 2169 0 0 0 2170 0 1:7 2169 0 0 0 2170 0 1:8 2168 0 0 0 2169 0 ================================================================================
History
This command was first available in ExtremeXOS 11.4.
Platform Availability
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.