unconfigure stacking

unconfigure stacking {node-address node_address | slot slot_number}

Description

This command resets most stacking parameters to the default or unconfigured values.

Syntax Description

node_address

Specifies the MAC address of a node in the stack. To view the MAC addresses for all nodes in a stack, enter the show stacking command.

slot_number

Specifies the slot number of the target node. To view the slot numbers, enter the show stacking command.

Default

N/A.

Usage Guidelines

Run this command from any node. If you do not specify a target node, the stacking parameters on all nodes are reset.

This command resets the stacking parameters shown in the following table.
Table 1. Stacking Configuration Items, Time of Effect and Default Value
Configuration Item Takes Effect Default Value

Stacking Mode

At boot time

Disabled

Slot Number

At boot time

1

Master-Capable

At boot time

Yes

License Restriction

At boot time

Not Configured

Priority

At next master election

Automatic

Alternate IP Address

Immediately

Not Configured

Stack MAC

At boot time

Not Configured

This command does not reset the stacking parameters configured with the following commands that use the stacking-support keyword:

Example

To unconfigure the stacking parameters of all nodes in the stack topology:

unconfigure stacking

History

This command was first available in ExtremeXOS 12.0.

Platform Availability

This command is available with all licenses and platforms that support the SummitStack feature. For information about which licenses and platforms support the SummitStack feature, see the ExtremeXOS 32.2 Feature License Requirements document.