This command displays session up/down trap reception for BFD.
snmp | Configure SNMP specific settings. |
traps | Configure SNMP Trap generation settings. |
bfd | BFD-specific traps. |
Not applicable.
Use this command to display SNMP trap reception for BFD session up/down.
The following command displays SNMP Trap configuration for BFD:
#show snmp traps bfd SNMP Traps for Session Down : Enabled SNMP Traps for Session Up : Enabled SNMP Traps Batch Delay : 1000 ms
This command was first available in ExtremeXOS 15.5.
This command is available on ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, and X695 series switches.