configure network-clock ptp boundary add unicast-slave

configure network-clock ptp boundary add unicast-slave ipv4_address {vlan} vlan_name

Description

Add an entry to the unicast slave table for a PTP clock instance. This command is available only for boundary clocks.

Syntax Description

boundary Boundary clock instance.
unicast-slave IP addresses that are potential slaves to the local clock.
ipv4_address IPv4 address.
vlan VLAN.
vlan_name Name of the specific VLAN to add for the PTP clock instance.

Default

The default configuration of clock port is slave mode.

Usage Guidelines

Use this command to add an entry to the unicast slave table for a PTP clock instance.

Example

The following command adds a static unicast slave entry to the PTP clock port lpbk-slave in the boundary clock:

# configure network-clock ptp boundary add unicast-slave 192.168.15.20 vlan lpbk-slave

History

This command was first available in ExtremeXOS 15.1.

Platform Availability

This command is available on the ExtremeSwitching X460-G2 platform.

Note

Note

PTP commands can be used only with the Network Timing feature pack.