Display Current Configuration on Fabric IPsec Gateway VM

About this task

Perform this procedure to display the parameters configured currently on the Fabric IPsec Gateway Virtual Machine (VM).

1. Enter Fabric IPsec Gateway Configuration mode:

   enable

   virtual-service WORD<1-128> console

   

   Note

   Type CTRL+Y to exit the console.

2. Display the parameters currently configured on the VM:

   show running-config

Example

Displaying the parameters configured on Fabric IPsec Gateway VM:

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> show running-config
set global ipsec-tunnel-src-vlan 125
set global ipsec-tunnel-src-ip 192.0.2.1/24
set global lan-intf-vlan 30
set global lan-intf-ip 192.0.2.10/24
set global lan-intf-gw-ip 192.0.2.25
set global fe-tunnel-src-ip 192.0.2.55
set global wan-intf-gw-ip 192.0.2.11
set global mtu 1950
set ipsec 1 auth-key ******
set ipsec 1 fe-tunnel-dest-ip 192.0.2.70
set ipsec 1 encryption-key-length 128
set ipsec 1 admin-state enable