Load Configuration File to Fabric IPsec Gateway VM

About this task

Perform this procedure to load a configuration file to the Fabric IPsec Gateway Virtual Machine (VM).

Procedure

  1. Enter Fabric IPsec Gateway Configuration mode:

    enable

    virtual-service WORD<1-128> console

    Note

    Note

    Type CTRL+Y to exit the console.

  2. Load a specific configuration file to the VM :

    load WORD <1-255>

Example

Loading a configuration file to the VM.

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> load coupled.cfg

Variable Definitions

The following table defines the variable for load command.

Variable Value
WORD <1-255> Specifies the configuration file name.
9037147-00 Rev AB