View Statistical Graph of Remote IS-IS Interface Receiving Control Packet
Note
This procedure only applies to the VSP 7400 Series.
About this task
Perform this procedure to view statistical graph of the remote IS-IS interface receiving control packets.
Procedure
- In the navigation pane, expand the folders.
- Select IS-IS Remote.
- Select the Interfaces tab.
- Select an interface.
- Select the Graph button.
- Select the Interface Receiving Control Packets tab.
Interface Receiving Control Packets Field Descriptions
Use data in the following table to use the Interface Receiving Control Packets tab.
|
Name |
Description |
|---|---|
|
Hello |
Indicates the number of IS-IS Hello PDUs seen in this direction at this level. Point-to-Point IIH PDUs are counted at the lowest enabled level: at L1 on L1 or L1L2 circuits, and at L2 otherwise. |
|
LSP |
Indicates the number of IS-IS link-state packet (LSP) frames seen in this direction at this level. |
|
CSNP |
Indicates the number of IS-IS Complete Sequence Number Packet (CSNP) frames seen in this direction at this level. |
|
PSNP |
Indicates the number of IS-IS Partial Sequence Number Packets (PSNPs) seen in this direction at this level. |
|
AbsoluteValue |
Displays the counter value. |
|
Cumulative |
Displays the total value since you opened the Stats tab. |
|
Average/Sec |
Displays the average value for each second. |
|
Minimum/Sec |
Displays the minimum value for each second. |
|
Maximum/Sec |
Displays the maximum value for each second. |
|
Last Val/Sec |
Displays the last value for each second. |