Edit Chassis Information

About this task

Edit the chassis information to make changes to chassis-wide settings.

Procedure

In the Device Physical View tab, select the device.
In the navigation pane, expand Configuration > Edit.
Select Chassis.
Select the Chassis tab.
Edit the necessary options.
Select Apply.

Chassis Field Descriptions

Use the data in the following table to use the Chassis tab.


Name	Description
Type	Specifies the chassis type.
ModelName This parameter does not apply on all platforms.	Specifies the chassis model name.
BrandName This parameter does not apply on all platforms.	Specifies the chassis brand name.
PartNumber	Specifies the device part number.
SerialNumber	Specifies a unique chassis serial number.
HardwareRevision	Specifies the current hardware revision of the device chassis.
NumSlots	Specifies the number of slots available in the chassis.
NumPorts	Specifies the number of ports currently installed in the chassis.
BaseMacAddr	Specifies the starting point of the block of MAC addresses used by the switch for logical and physical interfaces.
MacAddrCapacity	Specifies the number of routable MAC addresses based on the BaseMacAddr.
Temperature This parameter does not apply for all platforms.	Specifies the temperature of the device measured in degrees Celsius.
MacFlapLimitTime This parameter does not apply for all platforms.	Configures the time limit for the loop-detect feature, in milliseconds, for MAC flapping. The value ranges from 10–5000. The default value is 500.
AutoRecoverDelay	Specifies the time interval, in seconds, after which auto-recovery runs on ports to clear actions taken by CP Limit or link flap. The default is 30.
MTUSize	Configures the maximum transmission unit size. The default varies depending on the platform: 5420 Series - 1950 bytes 5520 Series - 1950 bytes VSP 4450 Series - 1950 bytes VSP 4900 Series - 1950 bytes VSP 7200 Series - 1950 bytes VSP 7400 Series - 1950 bytes VSP 8200 Series - 1950 bytes VSP 8400 Series - 1950 bytes VSP 8600 Series - 1950 bytes XA1400 Series - 1950 bytes
MgidUsageVlanCurrent	Number of MGIDs for VLANs currently in use.
MgidUsageVlanRemaining	Number of remaining MGIDs for VLANs.
MgidUsageMulticastCurrent	Number of MGIDs for multicast currently in use.
MgidUsageMulticastRemaining	Number of remaining MGIDs for multicast.
DdmMonitor	Enables or disables the monitoring of the DDM. When enabled, the user gets the internal performance condition (temperature, voltage, bias, Tx power and Rx power) of the SFP/XFP. The default is disable.
DdmMonitorInterval	Configures the DDM monitor interval in the range of 5 to 60 in seconds. If any alarm occurs, the user gets the log message before the specific interval configured by the user. The default value is 5 seconds.
DdmTrapSend	Enables or disables the sending of trap messages. When enabled, the trap message is sent to the Device manager, any time the alarm occurs. The default is enable.
DdmAlarmPortdown	Sets the port down when an alarm occurs. When enabled, the port goes down when any alarm occurs. The default is disable.
PowerUsage This parameter does not apply on all platforms.	Specifies the amount of power the CPU uses.
PowerAvailable This parameter does not apply on all platforms.	Specifies the amount of power available to the CPU.