Configure an IP Address for a Segmented Management Instance
Note
This procedure does not apply to VSP 8600 Series.
Use this task to configure and view IPv4 address information for a Segmented Management Instance.
Before you begin
-
Ensure the IP address you plan to assign is not in use by an existing VLAN or CLIP IP subnet configured on the switch.
-
If the DHCP client is configured for a Segmented Management Instance, you must manually disable the client. Configuring an IP address does not automatically disable the DHCP client.
Procedure
- In the navigation pane, expand .
- Select Mgmt Instance.
- Select Mgmt.
- Select the IpAddress tab.
- Select Insert.
- Select the Segmented Management Instance interface type.
- Type the address information.
- Select Insert.
IpAddress Field Descriptions
Use the data in the following table to use the IpAddress tab.
|
Name |
Description |
|---|---|
|
InstanceId |
Specifies the interface instance. |
|
Address |
Specifies IPv4 address for the interface instance. Ensure that the management CLIP IP address does not fall into the range of a configured VLAN IP address range as this is not allowed. |
|
Mask |
Specifies the subnet mask of the IP address. |
|
AddrOrigin |
Shows the IP address origin. |
|
IntfName |
Shows the interface name. |