Configure Multi-area SPB Layer 2 I-SID List

Note

Note

This procedure only applies to the VSP 7400 Series.

About this task

Perform this procedure to configure layer 2 I-SID list.

Procedure

  1. In the navigation pane, expand the Configuration > IS-IS folders.
  2. Select MultiArea.
  3. Select the L2 ISID List tab.
  4. Select Insert.
  5. Configure the layer 2 I-SID list parameters.
  6. Select Insert.

L2 I-SID List Field Descriptions

Use data in the following table to use the L2 I-SID List tab.

Name Description

Name

Specifies the name of the layer 2 I-SID list.

RangeStart

Specifies the I-SID value as the starting range for the layer 2 I-SID list.

RangeEnd

Specifies the I-SID value as the ending range for the layer 2 I-SID list.