Viewing Fabric Attach interface configuration

Use this procedure to view FA interface configuration.

Procedure

  1. To enter User EXEC mode, log on to the switch.
  2. View all FA interfaces (ports and MLTs):

    show fa interface

  3. To view FA interface configuration on ports, use one of the following commands:

    • View FA configuration on all ports:

      show fa interface port

    • View FA configuration on a specific port, enter:

      show fa interface port [{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}]

  4. To view FA interface configuration on MLTs, use one of the following commands:

    • View FA configuration on all MLTs:

      show fa interface mlt

    • View FA configuration on a specific MLT:

      show fa interface mlt [<1-512>]

Example

The following example displays sample outputs for the show fa interface command.

Switch:1>show fa interface

=====================================================================
                            Fabric Attach Interfaces
=====================================================================
INTERFACE    SERVER   MGMT     MGMT     MSG AUTH MSG AUTH    ORIGIN 
             STATUS   ISID     CVID     STATUS   KEY       
---------------------------------------------------------------------
Port2/10     enabled  0        0        enabled  ****      
Port4/6      enabled  0        0        enabled  ****      
Port4/11     enabled  0        0        enabled  ****      
Mlt2         enabled  0        0        enabled  ****      

---------------------------------------------------------------------
 4 out of 4 Total Num of fabric attach interfaces displayed
---------------------------------------------------------------------

The following is a sample output for the show fa interface command for the port 2/10.

Switch:1>show fa interface port 2/10

==================================================================
                            Fabric Attach Interfaces
==================================================================
INTERFACE    SERVER   MGMT     MGMT     MSG AUTH MSG AUTH   ORIGIN   
             STATUS   ISID     CVID     STATUS   KEY         
------------------------------------------------------------------
Port2/10     enabled  0        0        enabled  ****        

------------------------------------------------------------------
 1 out of 4 Total Num of fabric attach interfaces displayed
------------------------------------------------------------------

The following is a sample output for the show fa interface command for the MLT 2.

Switch:1>show fa interface mlt 2

===================================================================
                            Fabric Attach Interfaces
===================================================================
INTERFACE    SERVER   MGMT     MGMT     MSG AUTH MSG AUTH   ORIGIN     
             STATUS   ISID     CVID     STATUS   KEY         
-------------------------------------------------------------------
Mlt2         enabled  0        0        enabled  ****        

-------------------------------------------------------------------
 1 out of 4 Total Num of fabric attach interfaces displayed
-------------------------------------------------------------------

Variable definitions

The following table defines parameters for the show fa interface port command.

Variable

Value

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

The following table defines parameters for the show fa interface mlt command.

Variable

Value

<1–512>

The valid range for MLT ID.
9037147-00 Rev AB