View RMON Application Host Statistics

View application host statistics to see traffic statistics by application protocol for each host.

Procedure

To enter User EXEC mode, log on to the switch.
View RMON application host statistics:

show rmon application-host-stats WORD<1–64>

Example

Switch:1# show rmon application-host-stats ?
  WORD<1-64>  Select one of these application protocols
              {TCP|UDP|FTP|TELNET|HTTP|RLOGIN|SSH|TFTP|SNMP|HTTPS}
Switch:1# show rmon application-host-stats FTP

================================================================================
                          Rmon Application Host Stats
================================================================================
HOSTADDR         INPKT      OUTPKT     INOCT      OUTOCT     CREATETIME        
--------------------------------------------------------------------------------
192.0.2.10        0          0          0          0          10/09/15 17:29:54

Note

Protocol support can vary across platforms.

Variable Definitions

The following table defines parameters for the show rmon application-host-stats command.


Variable	Value
WORD<1–64> Note: Exception: the rlogin application is only supported on VSP 8600 Series. However, RMON2 counts application packets received on any platform on which the application is not enabled or supported, before dropping them.	Specifies one of the following application protocols: TCP, UDP, FTP, TELNET, HTTP, rlogin, SSH, TFTP, SNMP, HTTPS.