Configuring SPBM IPv6 Layer 3 VSN using EDM

About this task

After you have configured the SPBM infrastructure, you can enable SPBM Layer 3 Virtual Services Network (VSN) to advertise IPv6 routes across the SPBM network from one VRF to another using the following procedure.

SPBM Layer 3 VSN uses IS-IS to exchange the routing information for each VRF.

Before you begin

Procedure

  1. In the navigation pane, expand Configuration > IPv6.
  2. Click IPv6-VPN.
  3. Click the VPN tab.
  4. Click Insert.
  5. Click the ellipsis [...], and select a VRF.
  6. Click Ok.
  7. Click Insert.
  8. In the IsidNumber column, double-click the 0 value, and then enter the service instance identifier (I-SID) to assign to the IPv6-VPN.
  9. Click Apply.
  10. In the Enable column, select true or false.
  11. Click Apply.
  12. In the navigation pane, expand Configuration > VRF Context View.
  13. Click Set VRF Context View.
  14. Click the VRF tab.
  15. Select a context to view.
  16. Click Launch VRF Context view.

    A new browser tab opens containing the selected VRF view

  17. In the navigation pane, expand Configuration > IPv6.
  18. Click IS-IS.
  19. Click the Redistribute tab.
  20. Click Insert.
  21. Configure the parameters as required.
  22. Click Insert.
  23. Click Apply.
9037147-00 Rev AB