Configure EAP auto-isid-offset

Note

This procedure does not apply to VSP 4450 Series, VSP 8600 Series, or XA1400 Series.

Before you begin

Enable EAP globally or on the port.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure an I-SID offset value:

eapol auto-isid-offset <0-15995903>
Enable EAP globally:

eapol enable
Confirm that your configuration is correct:

show eapol system

Examples

Configure an I-SID offset value and enable I-SID offset globally on the switch:

Switch:1> enable
Switch:1#config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#eapol auto-isid-offset 1000 
Switch:1(config)#eapol enable

View the current device configuration:

Note

Not all fields are supported on all hardware platforms.

Switch:1>show eapol system
================================================================================
                                  Eapol System
================================================================================
                     eap : disabled
           Eapol Version : 3
         non-eap-pwd-fmt : mac-addr
     non-eap-pwd-fmt key : ******
 non-eap-pwd-fmt padding : disabled
 auto-isid-offset status : disabled
 auto-isid-offset value  : 1000
--------------------------------------------------------------------------------

Variable Definitions

The following table defines parameters for the eapol auto-isid-offset command.


Variable	Value
`<0-15995903>`	Specifies the auto I-SID offset value. The default is 15995903.
enable	Enables auto I-SID offset. The default is disabled.